pinhole |
① coating viscosity too high, stirring time is too long. ② thick coating, solvent evaporation difficult. ③ not supporting the use of curing agents or curing dose too much, at the lack of time. ④ thinner is not supporting, or thinner volatile too fast. ⑤ surface was coated with oil pollution, water. ⑥ of the ambient temperature too high, or too much humidity. ⑦ air compressor in the oil-water separation enough. ⑧ spraying air pressure, small-calibre, spraying distance. ⑨ Road before the coating is not completely dry, dry coating, after the fast. |
① coating viscosity of the deployment of appropriate and placed a period of time after use. ② a thick coating can not, can not exceed 30 um. ③ supporting the use of curing agent, strictly according to weight ratio. High-temperature drying, be sure to let the volatile solvents are full time. ④ supporting the use of thinner. ⑤ clean surface treatment after construction. ⑥ appropriate increase of moisture, the water slowly. ⑦ regularly ranked oil, overhaul separator. ⑧ adjust the air pressure, normally 0.6 Mpa, master spraying distance. ⑨ repeatedly spraying, coating between the drying time to fully. |